This set of FinSciences quad fins is made up of two of our smaller 4.8-inch fins and two of our larger 5.7-inch fins.
This set has a pretty traditional quad-set feel, but will be faster than usual because our fins are smaller than those in a typical set. For those surfers not ready to downsize all the way to a set of four of our 4.8 inch fins, this is the ticket.
Specs, Quad Set of Two 4.8″ Fins and Two 5.8-inch Fins:
- Set area = 49.48 sq. inches (29.2 in the 5.7s, + 20.28 in the 4.8s)
- Area, each 5.7″ fin: 14.58 sq. inches
- Area, each 4.8″ fin: 10.14 sq. inches
- Height/depth: 5.68 inches lg., 4.8 inches sm.
- Foil: symmetrical (double)
- Anti-cavitation trailing edge
- Fits FCS
Note: Smalls are available in semi flex (glossy black, blue) or in stiff matte black.
Sizing of FSI Fins Compared to Typical Fins
Our fins have a lot of power. They generate a lot of hold and drive for their small size. (Read more about hold, drive, lift, and drag.)
Because they have a lot of power, your right-sized FSI fin will have an area smaller than what you’re used to. And because they are smaller, they have less drag. This means that you can accelerate more quickly, paddle more easily, or surf longer.
Basically we take a typical fin, chop off about 30 percent of its area, then replace about 5 percent in a more modern configuration. This removal of surface area and its skin-friction drag, is one of the key concepts behind our fins. Our fins resemble modern-day airplane wings and boat keels–because the science justifies it. Our fins are unlike dolphin fins that have dominated the market for the last 50 years.
Winglets are solid science, and they work.
Winglets and other features we use make these fins about 20 to 30 percent more efficient than larger, older styles, so you need to downsize by about 20 to 30 percent as compared to the fin or set of fins you typically use.
Example: If you typically surf a set of mediums in a thruster setup, fins that are usually about 14.5 sq. inches each, you are surfing 43.5 sq. inches of fin. Try our smalls. Our new small is 10.14 sq. inches, and a set of three is 30.42 square inches, a 30 percent reduction in fin surface area, and a 30 percent reduction in skin-friction drag.
Another example: If your longboard or SUP board has a center fin and two sidebites, calculate the area of your current fins, then try downsizing–try pulling off the sidebites and going with a single Wavegrinder 2 longboard-SUP fin. You will dramatically decrease the area of the fin, yet still get good hold and drive because of the winglets and other features of our fins.
FSI Fins, Areas in Sets
Because FSI’s current fins are symmetric, you can either get a set of the same fins, or mix smaller and larger fins to get the ride you want.
|Fin type||FSI size||Area, each||Area, set of 2||Area, set of 3||Area, set of 4|
|Shortboard fin||Small||10.14 sq. in.||20.28 sq. in.||30.42 sq. in.||40.56 sq. in.|
|Shortboard fin||Large||14.58 sq. in.||29.16 sq. in.||43.74 sq. in.||58.32 sq. in.|
|Longboard-SUP fin||WG2||30.60 sq. in.||61.20 sq. in.|